PC
TRISTAR® PC-FRN-HC(V5) GY
Manufacturer：Not recorded
Recorded properties
Record date：2026-11-08
| Property | Value | Unit |
|---|---|---|
| Density | 1.23 | g/cm³ |
| Melt flow rate | 5.0 | g/10min |
| Tensile strength | 62.1 | MPa |
| Elongation at break | 75.0 | % |
| Flexural modulus | 2213.0 | MPa |
| Notched impact strength | 801.0 | kJ/m² |
| HDT 1.8MPa | 135.0 | °C |
| HDT 0.45MPa | 126.0 | °C |
| Flame rating | {'burning_behav_5v_at_thickness_h': '5VA', 'glow_wire_flammability_index_gwfi': '960', 'glow_wire_ignition_temperature_gwit': '777', 'ul_94_flame_rating': 'V-0'} | — |
Test standard, specimen condition and source rights are not fully recorded. Values are for preliminary screening only; verify with the manufacturer before design or purchasing decisions.
Grade handling information to verify
The information below was automatically extracted from a material PDF and has not been individually reviewed. It is for preliminary reference only. Verify the exact grade’s manufacturer processing instructions, safety data sheet and equipment procedures before production; do not use candidate values directly as machine settings.
Matched by original PDF filename
- Storage
- Review the source for packaging, storage and opened-package instructions.
- Drying
- Candidate injection-molding recommendations: temperature 121 °C; time 3 - 4 h. Verify the source, grade and conditions.
- Equipment setup
- Candidate injection-molding recommendations: melt temperature 293 - 316 °C; mold temperature 71.1 - 93.3 °C. Verify the source, grade and conditions.
- Applications
- Candidate application areas in the source: electrical and electronics. Verify the source, exact use and applicable approvals.
Source: the matched material PDF; page numbers refer to the original PDF.
- Drying temperature：page 1
- Drying time：page 1
- Melt temperature：page 1
- Mold temperature：page 1
- Application areas：page 2
